The original tape of the orange PC endurance board. Only used for temporary protection of the edges of the board, it is not resistant to aging. In the installation project, the board should be cut according to size, and after cutting, special engineering tape must be used to seal the hole grid at the end of the board according to the installation regulations, replacing the original tape.
Strictly implement ROHS instructions.
Storage and transportation of orange PC endurance boards:
(1) Keep indoors and never allow direct sunlight or rain exposure
(2) Place it by hand and do not exceed a height of two meters. No heavy objects should be placed on the board, and there should be no hard objects between the boards.
(3) The storage room must be kept clean, dry, and free from dust intrusion. Other chemicals should not be stored indoors at the same time.
(4) When storing, do not damage or remove the protective film.
(5) When transporting orange PC endurance boards, they must be placed flat on a clean flat pallet with an area larger than the board. If necessary, they should be appropriately tied to avoid vibration and sliding. Attention should be paid to protecting the edges of the board from damage and keeping the double-sided protective film intact.